Warning: fread(): Length parameter must be greater than 0 in /var/www/enshop_opencart/system/library/cache/file.php on line 32Warning: fread(): Length parameter must be greater than 0 in /var/www/enshop_opencart/system/library/cache/file.php on line 32 L298 Dual H-Bridge Motor Driver

$14.90

In Stock

Availability: 98

Sales Volume: 30

back to top

Description:

LKV-HM3.0 dual H-bridge DC motor driver board using ST's L298N typical dual H-bridge DC motor driver IC, which can be used to drive DC motors or bipolar stepper motors. This driver board is small, light weight, but with a strong drive capability: 2A peak current and peak voltage of 46V.Although the chip with the automatic shut-off function when it is overheating , but installing the heat sink could make the chip temperature decreases, so that the drive performance is more stable.

Board has two current feedback detection interface to take power within the logic selects the terminal, four pull-up resistor selection terminal, 2-way and four-wire interfaces DC two-phase stepper motor interface, control motor direction indicator, four standard fixed mounting holes. This driver board could be used with smart programmable trolley, wheeled robots and variety of controllers.

Dual H driver module uses ST L298N dual full-bridge driver, an integrated monolithic circuit in a 15- lead Multiwatt and PowerSO20 packages. It is a high voltage, high current dual full-bridge driver designed to accept standard TTL logic levels and drive inductive loads such as relays, solenoids, DC and stepping motors. Two enable inputs are provided to enable or disable the device independently of the input signals. The emitters of the lower transistors of each bridge are connected together,and the corresponding external terminal can be used for the connection of an external sensing resistor. An additional supply input is provided so that the logic works at a lower voltage.

Specifications:

  • Driver: L298
  • Driver power supply: +5V~+46V
  • Driver Io: 2A
  • Logic power output Vss: +5~+7V (internal supply +5V)
  • Logic current: 0~36mA
  • Controlling level: Low -0.3V~1.5V, high: 2.3V~Vss
  • Enable signal level: Low -0.3V~1.5V, high: 2.3V~Vss
  • Max power: 25W (Temperature 75 cesus)
  • Working temperature: -25C~+130C
  • Dimension: 60mm*54mm
  • Driver weight: 48g
  • Other extensions: current probe, controlling direction indicator, pull-up resistor switch, logic part power supply

Features:

  • Light weight, small dimension
  • Super driver capacity
  • FWD protection
  • Heavy load Heat sink
  • 2 current probe port
  • Power selection switch
  • 4 pull up resistor switch
  • 2 DC motor/ 4 coil dual phrase stepper motor output
  • Motor direction indication LED
  • 4 standard mouting hole

Packing List:

  • 1x L298 Dual H-Bridge Motor Driver
Warning: SessionHandler::write(): write failed: No space left on device (28) in /var/www/enshop_opencart/system/library/session/native.php on line 21