In Stock

Availability: 1

Sales Volume: 20

back to top

AS-Land Rover 5 Patrol Obstacle Avoidance Mobile Car Kit was produced in 2015. It is designed according to the control subject of previous Undergraduate Electronic Competition. The external appearance of the baseplate of the supporting plate absorbs the pattern of Optimus Prime from Transformers. It is made of 2.5mm thick black light acryl materials. It is light, non-friable, non-conducting and nice.

On the lower baseplate, users can install Dual H Bridge DC Motor Drivers, Mini IR Detector Photoelectric Sensors, RB URF v1.1 Ultrasonic Sensors, GP2D12 IR Distance Sensors, Flame Sensors, Light Sensors, RB-421 2DOF Holders, MG995 SDOF Holders, and Electronic Blocks.

A fixed orifice between the power switch and charger connector can be convenient to the users for debugging robots without taking the rechargeable batteries out. On the upper baseplate, users can install Arduino Mega168 Controllers, Arduino Mega1280 Controllers, and Robotboard v1.2 51 SCM Controllers. If more electronic equipment is needed to be installed, users can add more baseplates. In this way, the humanized design concept is really realized.


  • Motor Voltage:7.2V
  • Working Current:300mA-2.5A
  • Maximum torque :10Kg*cm
  • Reduction Ratio: 86.8:1
  • Grade Ability: >30°
  • Speed:1 Km/hr
  • Chassis Platform Dimensions:245mm*225mm*74mm
  • Upper Baseplate Dimensions:146mm*194mm
  • Lower Baseplate Dimensions:130mm*96mm
  • Baseplate Thickness:2.5mm

Note:The chassis of RP5 Tracked Robot is assembled by the manufacturer, but the upper and lower baseplates need assembling by the users themselves according to the installation of equipment.

Packing List:

  • 1 x Land Rover 5 Mobile Car Chassis
  • 1 x M3*6+50 copper Fixed Set
  • 1 x Carduino Uno R3 Controller
  • 1 x Sensor Shield V5.0
  • 1 x L298 Dual H-Bridge Motor Driver
  • 3 x Mini IR Line Tracking Sensor
  • 3 x Mini IR Detector Photoelectric Sensor
  • 1 x Support plate Kit
  • 1 x Sensor mounting bracket
  • 1 x Charging interface switch kit
  • 2 x 3Pin Jumper Wire
  • 6 x 3Pin Anti-Plug Wire
  • 3 x servo extension cord
  • 1 x Power Cable Black
  • 1 x Power Cable Red
  • 2 x Power Cable
  • 10 x Black tie
  • 1 x terminal blocks
  • 9 x M3*6 plus screw
  • 9 x hexagon nut
  • 7 x M3*6+10 copper cylinder
  • 1 x 7.4V Lipo Battery
  • 1 x Lithium Battery Charger
  • 1 x 7.4v Power Line
  • 1 x screwdriver